Text, Kawasaki. www dot Kawasaki dot com.
Assembly Instructions. Teryx K R X 4 1000. Tail Light Guard. Part # 9 9 9 9 4 dash 1 7 4 9. 30 Minutes Estimated Assembly Time. Before you begin, read through the assembly instructions and check that all parts are present. Please note that Kawasaki cannot assume any responsibility for damage resulting from incorrect installation. Kawasaki recommends that all genuine accessories should be fitted by an authorized Kawasaki dealer.
Install the Rear Bumper (9 9 9 9 4 dash 1 3 0 3) before installing this accessory. Remove the four plastic caps on top of the rear bumper.
A man inserts a screwdriver into holes on the bottom of the rear bumper bar. He pushes the screwdriver upwards to pop the caps off the bar. Text, Park the vehicle on level ground, set the parking brake, and turn off the ignition switch.
He places a triangular bar onto the bumper and the C-pillar. He slides a washer over a bolt and inserts the washer into a hole. He turns the bolt to tighten it. Text, Place the Right rear light guard in position and screw two M 8 hex flange bolts and two formed washers, with the flat of the washer against the bolt head, through the holes in the bumper. Fingers tighten.
He places brackets onto the Right rear light guard. He holds them in place while inserting screws into holes. He turns them with his fingers. Text, Position the right exterior bracket and right interior bracket around the C-pillar to fix the right rear light guard in place and screw two M 8 button head screws and two spring lock washers.
He uses a t-handle screwdriver on the screws to tighten them further. He then uses a torque wrench to tighten the bolts on the rear bumper. Text, Tighten all the bolts. Torque-M 8 bolts: 19 N-m (1.94 k g f per meter, 14 feet per pound).
Repeat the steps for the Driver side.
A Teryx K R X 4 1000 drives down a rocky dirt path. Text, Kawasaki. www dot Kawasaki dot com.